Bostitch EHF1838K Engineered Hardwood Flooring Stapler

Worked for about ten feet of BR-111 5/16″ thick chestnut flooring before dying on me. Trigger wouldnt pull and nose was stuck in. My PSI was set at 62 pounds, the staples used were the ones that came with the kit and I set up the gun quickly using the supplied directions. Called Bostitch for support and they directed me to an authorized warranty center (Apollo Power Equipment in Niles Illinois) to have the gun looked at. Went there at 10:15AM and left about 11:30 with the gun fiddled with but NOT repaired. Called the vendor who sold me the gun (SpeedyNails) and they said they would not replace the gun and that it was a warranty issue. Took it to Pro-Mar in Chicago and fixed it in about 15 minutes. Got back to jobsite and used it successfully for about three hours before I had to leave for the day. I was impressed with how quiet it was and how the staples drove in cleanly and consistently. However, the safety button on the side of the gun didnt seem to want to stay in “fire” mode and clicked off with the slightest touch. It was quite maddening to have to pull the gun away from the work, flip the safety and then re-engage to the work to fire more staples. It should have a more clear detent position on or off. Hooked it up this morning and it died again with the same symptoms after about an hour and a half of use. I briefly considered frisbeeing it from the 25th floor. Bostitch is sending me another gun to replace this one and I hope it works better. I’ve never had ANY issue with my other Bostitch nail and staple guns. I will update this review after I’ve received and used the replacement.